ifting platforms have been widely used in various industries, and the existence of lifting platforms has greatly reduced the difficulty of people working at heights.

The operation process of the hydraulic lifting platform specification:

1. The lifting table has been strictly debugged when it leaves the factory. Any adjustment of the pressure regulating valve will make the system run abnormally. Non-professionals are not allowed to adjust the pressure regulating valve arbitrarily.

2. Before using the platform, carefully check the hydraulic and electrical systems to ensure that there is no leakage or exposure, and that the joints and fasteners are not loose before use.

3. When the lifting platform is working, the outriggers must be supported. It is advisable to draw the black and red dividing line to obtain the largest supporting area as much as possible. Adjust the height of the outriggers to make the platform level (subject to the fact that the walking wheels will leave the ground). Use sleepers.

4. Turn on the power, start the motor, do no-load lifting, check that the hydraulic system is normal, and then load it for use.

5. The center of gravity of the load should be at the center of the work surface as much as possible. The movable doors at both ends of the protective railing should be closed and locked before working.

6. The lifting platform should work strictly according to its specified load capacity. Overload work may cause damage to personnel and equipment. During the rising and falling process of the lifting platform, it is strictly forbidden for the operator to walk and shake.

7. If there is abnormal noise when the lifting platform is working, it should be stopped immediately for inspection to avoid equipment and personnel injury.

8. After the work is completed, the platform should be lowered, the power supply should be cut off, the outriggers should be folded up, and the platform should be pushed to the designated position.